Put the new film in the bottom, where the spent spool was. This will switch off the meter and prevent draining of battery power. Edited by Hans Kerensky member 8 years ago. There’s a sequence on Youtube which shows how to load film into a Yashicamat: Edited by member 10 years ago. I just got a Yashica Mat g. I mostly used the 11×14 format and the results were amazing.

Ian Tindale 11 years ago. That paper backing on film is the light proof paper. Freestyle Photo sells black plastic containers, but you could as easily put the film in black plastic bag if you’re worried about it. Please try again later. Continue winding the film until the “start” mark on the film leader paper lines up with the RED triangular “start” mark for film. Amazon Music Stream millions of songs. AluminumStudios 11 years ago. Put the new film in the bottom, where the spent spool was.

Then, it’s safe to open the back of the camera. Ysshica HOOD 30 mm bayonet type Use of lens hood is recommended for subjects in bright light, sea or snow scenes, and to prevent unnecessary stray light from falling on the lens. Use a Wein Air battery.

The even distribution of light over the entire subject area will assure better color balance. Hans Kerensky Posted 8 years ago.

Yashica Mat 124G film loading

I started using the markings for all film since I found that the markings resulted in my first frame on Kodak film Fuji was fine getting screwed up by light from the film loading. I wouldnt really mind all this if the camera at least worked.


I simply pull it off, and use it then. Because I accidentally ripped that in two. I don’t mind the few marks around the body but what I got was not even workable. The ‘1’ doesn’t just zip across the window.

Amazon Restaurants Food delivery from local restaurants. Is it the small piece of paper or whatever that kept the roll from unrolling originally?

Horseshoot 10 years ago. If it doesn’t stop, then the camera has a problem. Amazon Rapids Fun stories for kids yashiva the go. When I first got my Voigtlander Brilliant in ’boutI quickly became adept at loading film after allowing one roll to unspool.

Flm that you need it fil but I found this site useful for many manuals. That photo was helpful.

It is on a disk that is slowly revolving as you wind the film. Take the old spool out of the bottom, move it to the top to be the new take-up spool.

Available from these sellers. The next time you load film, make sure that you have the plate in the 12 or 24 position to relate to either or film. After closing the Back Cover, wind the crank-handle until the figure “1” appears in the Exposure Counter Window. Ian’s step-by-step for the C is pretty much identical to my plain ol’ Yashica-Mat, i.

Warranty & Support

The little numbers are a courtesy so you know howm any shots fim have taken and how many are left. Learn more about Amazon Prime. By checking this scale, you can easily determine before shooting the extent over which the objects will appear sharp and clear. So I got back 3 rolls worth of negatives today and the first two pictures of each roll are missing.


First, turn the Crank-handle all the way in a clock wise motion toward [1]. When you finish shooting the roll, wind on until you feel the tension release. Write a customer review. Does anyone perhaps have a video showing how to load film? I read that I would have to paste the seal and put the film in lightproof paper or something. How much should I hand wind it before closing up the camera? See all 3 reviews.

Yashica Mat G film loading | Photography Forums

Plug the PC cord of the flash unit into the Flash Contact of the camera. I don’t know if others have had this happen, but on mine it is every time. Obviously, that’s 124 working for me.

Use the above address for a check, M. What is weird yaashica my Yashica MAT non-G is at the end of each roll, the little piece of paper is always detached, and stuck to the camera.

Horseshoot Mine is often torn too. Turn the Aperture Control Dial and coincide the yellow follower needle coupled to the aperture mechanism with the red meter pointer coupled to the shutter mechanismboth visible in the Exposure Indicator Window.